paper goblin

I hear a voice that says  "You should assemble real Goblin500 quickly!" from around me .

But I tried to produce a paper canopy type of goblin.

paper-canopy is a favorite canopy,
because cost-performance is so good.

I have bought goblin500, So,I tried to mimic it.

However, in order to create paper-canopy, I must write a pattern to allow draping first.

So, I decided to wake up pattern with 3DCG software .

3dsmax.

First, I need to get the three sides of the goblin figure that would be helpful.

 I can't get the drawing, I decided to go with the photos.

Goblin500 photos of the original design has been up to HELIDIRECT site, I decided to use it. (Because It has a picture right beside and front,above)to guide modeling.

I modeled with reference to this guide.

I converted to the exploded view this modeling per each side,.

I've teamed up to try once in three dimensions at this stage.

Something big. Reduced 95%, and then paste it into a 2D drawing software. development view this, now, I draw the facade design.

I draw the tail as well.

This is the trial version. Logo of the tail, it says 500 originally, I write 100, so 100 class heli.

Also to seem Goblin's skid, I decided to put the option parts.

I compare it to the actual canopy.



Somehow, how well the range permitted?

By the way, This is a full brushless mini cp.
In the previous flight, wiring of the tail motor was broken when I crashed.

Tail boom made from a solid rod with outside wiring seems to beat with the rotor.

Where hits a tip of the rotor, would break the wirering.

meaning the protection of this also use this full cowl.

It is a temporary ｆorm　for trial version.